Macrium Support Forum

Macrium Support Forum
Macrium Support Forum    RSS 2.0  RSS Feed      KB
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
 All Forums
 Reflect v4
 Disk Imaging
 unable to image drive - XML error
 Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

bobj
Starting Member

USA
4 Posts

Posted - November 19 2010 :  15:39:35  Show Profile
Note - system has 2 internal hard drives which are mirrored.

When I attempt to image one of the drives (either drive), this is the error that I receive:

XML Validation: Error - "<disk>' is not a valid disk number

I tried to edit the XML file but am still getting errors.

Merlin
Advanced Member

834 Posts

Posted - November 19 2010 :  17:24:40  Show Profile
Some thoughts until Nick, et. al. stop by:
Is it "dynamic" RAID?
If so, it's not supported.

If it's hardware RAID, are those the disks that were in the system when the XML was originally created?
Maybe delete the XML and create a new one?
Are you using the registered version?

Edited by - Merlin on November 19 2010 17:58:16
Go to Top of Page

bobj
Starting Member

USA
4 Posts

Posted - November 19 2010 :  19:10:26  Show Profile
System has 2 drivers - mirrored - and set up as dynamic.

Go to Top of Page

Merlin
Advanced Member

834 Posts

Posted - November 19 2010 :  21:35:03  Show Profile
Dynamic drives aren't supported.
Go to Top of Page

bobj
Starting Member

USA
4 Posts

Posted - November 22 2010 :  15:53:13  Show Profile
thanks for the reply, any plans to have support for dynamic disks in a future release?
Go to Top of Page

john.p
Moderator

871 Posts

Posted - November 22 2010 :  16:04:49  Show Profile
Yes, we are working on Dynamic disk support.

Kind Regards
John - Macrium Support
Go to Top of Page

bobj
Starting Member

USA
4 Posts

Posted - November 22 2010 :  16:21:29  Show Profile
John,

Any idea when we can expect Macrium to support Dynamic Disk imaging?
Go to Top of Page

john.p
Moderator

871 Posts

Posted - November 22 2010 :  16:49:27  Show Profile
Sorry, I can't give you an ETA on that feature at the moment.

Kind Regards
John - Macrium Support
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
Macrium Support Forum © Paramount Software UK Ltd Go To Top Of Page
This page was generated in 0.92 seconds. Snitz Forums 2000